DryBoost UV

$114.95

NOW SHIPPING!

DryBoost UV® is a maintenance system for your rechargeable hearing aids or amplifiers. Accommodates most charging bases so you can recharge your devices while sanitizing and drying them at a temperature appropriate for rechargeable devices.

Description

With a precisely-controlled drying temperature that was designed specifically for use with rechargeable batteries, DryBoost UV is a great companion to your hearing instruments. The gentle heat works with a fan to create circulation around your hearing instruments and charging base, pulling the moisture from them and helping to prolong device life, reduce service issues, and increase audio performance. DryBoost UV also utilizes a UV-C lamp to provide sanitization of your hearing instruments while they are being charged and dried. There is an extra USB output on the rear of the unit, allowing you to charge a phone or other electronic device while your hearing instruments are being cared for inside the unit. DryBoost UV – combining drying, sanitizing, and charging.

Accommodates most charging bases so you can recharge your devices while sanitizing and drying them at a temperature appropriate for rechargeable devices. See the list of rechargeable bases and instruments that work with DryBoost UV.

  • Gentle heat (80°-85° F) for drying rechargeable devices – 6-hr. drying cycle
  • UV-C lamp for sanitizing – reduces bacteria* during 5-min. cycle
  • Unit shuts off automatically at the end of the cycle – batteries will continue to charge until charging is complete
  • Additional USB output on rear so you can charge other devices at the same time.
  • 1 year warranty

*Reduces 99.9% of bacteria, specifically Staphylococcus Aureus.

Electrical Characteristics

  • Input Power: 100-240 volts ~ 50/60 Hz   0.8A
  • Output: 9 volts, 3000mA

NOTE: Once the UV-C cycle is finished (5-min.), the drying cycle (6-hrs.) begins. The fan inside DryBoost UV starts once the drying cycle is underway.

Reviews

There are no reviews yet.

Be the first to review “DryBoost UV”

Your email address will not be published. Required fields are marked *

Frequently Asked Questions

Tweak Enhance has four listening modes: Conversation, Restaurant, Traffic, and Outdoors. The noise modes suppress background noise. The rocker switch is used to switch between listening modes.

Press and hold the lower portion of the rocker switch for two seconds then release. Do the same to switch to the other programs.

Enhance-switching listening modes

Once setup is complete, every time you turn on your Tweak Enhance, it will revert to the last program and volume setting you used.

Tweak Enhance includes one set of accessories: a pack of the most commonly used sound tubes (size 2B, right and left) and domes/tips. However, other sizes are available.

It is important for the sound tube and tip to fit properly in your ear. If you need a different size tip or tube, call 1-888-815-3240 for assistance. You can also order online:  https://www.eartech.com/product/simply-tweak-enhance-and-refocus-replacement-tips-and-tubes/

The sound tube delivers amplified sound into your ear. Sound tubes that shipped with your Tweak Enhance and sleeve tips should be tried first. The sound tubes are size 2B. 

If you get feedback or whistling, change to a more closed tip. Also try decreasing the volume.

It is important for the sound tube and tip to fit properly in your ear. If you need a different size tip or tube, or if you continue to have a problem, call 1-888-815-3240 or assistance. 

You can also order online:  https://www.eartech.com/product/simply-tweak-enhance-and-refocus-replacement-tips-and-tubes/

Make sure the tip/dome is not clogged.

Fully charge the battery.

Make sure the hearing aid case and sound tube are clean and dry. (Refer to page 51 in the Enhance user manual.)

Make sure the hearing aid case is positioned correctly behind the ear, and that the tip is positioned properly in the ear canal.

Make sure the volume is turned up, by tapping the upper portion of the rocker switch.

Excessive ear was can prevent sound from entering the ear. Contact your physician.

Changes in your hearing can affect how you hear with Tweak Enhance. Contact a hearing healthcare professional if you suspect any change in your hearing condition.

Tweak Enhance may need to be reset. See page 44 of the user manual for instructions. Follow prompts on-screen to set up the hearing aid.

 

Tweak Enhance is a sophisticated OTC hearing aid utilizing
innovative technology. This unique device allows you to select and set your
desired amplification setting from a range of acoustic alternatives.

Yes, in any listening mode, you can still adjust the volume using the rocker switch. Pressing the upper portion of the rocker switch increases the volume, while the lower portion reduces the volume. 

As you increase/decrease the volume, you will hear a single beep for each sound level. Also, when you reach the highest/lowest level of volume, you will hear beep sounds for each sound level.

Enhance illustration of increasing/decreasing volume level.

 

To turn ON, press and hold the upper portion of the rocker switch until you hear a beep (approx. 3 seconds) then release. While you are holding the rocker switch, it will turn green. The green light will turn off once the hearing aid is ON.

To turn OFF, again press and hold the upper portion of the rocker switch until you hear a beep (approx. 3 seconds) then release. While you are holding the rocker switch, it will turn blue. The blue light will turn off once the hearing aid is OFF.

Also, the hearing aids will automatically power OFF once they are seated properly in the charging base. However, after removing the hearing aids from the base it will be necessary to power them ON using the rocker switch.

illustration of how to turn on/off Enhance

Tweak Enhance is powered by a lithium polymer battery that is rechargeable. It’s best to charge your hearing aid completely prior to each use.

When not in use, turn off the hearing aid to prevent unnecessary battery drain or leave it in the charging base. See page 46 of user manual for instructions on turning power on/off.

Enhance hearing aids have a non-removable lithium-polymer battery. It is not user-changeable. Call Tweak Support for assistance – 1-888-815-3240.

Time to fully charge:
Approximately 3 hours

Battery life of full charge:
Approximately 20 hours
Keep in mind some functions of the hearing aid (volume level, noise compression, etc.) require more energy than others. You may find the battery needs recharging sooner than 20 hours.

No. Moisture is the number one enemy of hearing instruments. It can damage the microphone and other components, resulting in costly repairs. Don’t wear the device while taking a bath, shower, spa treatment or while swimming. (See page 55 of the user manual for a list of tips.)

We recommend the daily use of a DryBoost UV drying appliance. These dryers are available on the Accessories page of the eartech site.

The Tweak device has a best-in-class feedback management system. However, when your hand is near the device, you may hear a whistling noise, which is called “feedback”. This may be caused by amplified sound bouncing off your hand back into the instrument. The noise usually quits when you take your hand away.

If the whistling doesn’t stop once you’ve moved your hand away, ensure that the amplifier case is positioned properly behind the ear, and that the tip is positioned properly in the ear canal.

Try adjusting the volume. Tap the lower portion of the rocker switch to decrease volume.

Make sure the dome/tip and sound tube are not clogged with wax or other debris. (Refer to page 52 of the user manual.)

Instead of the sleeve tip, consider using one of the more closed domes.

Try adjusting the equalizer via the Enhance app – decrease the higher frequencies.

If the above fails to reduce feedback, contact Tweak Support at 1-888-815-3240.

Yes, Tweak Enhance has a 45-day trial period. After using Enhance for 45 days, you can return it for a full refund.

1.800.327.8547